How to replace the lamp unit
Required tools: Manual Phillips screwdriver; gloves.
Optional tool: 5/32Ó or 4mm Allen wrench.
1. Turn off the TV and unplug the power cord.
WARNING: Eye damage may result from
directly viewing the light produced by this lamp. Always turn off the TV and unplug the power cord before opening the lamp unit door.
2. STOP! Allow the lamp to cool for at least one (1) hour before replacing it.
WARNING: RISK OF
ELECTRIC SHOCK!
TO REDUCE THE RISK OF ELECTRIC SHOCK, NEVER REMOVE TV COVERS, EXCEPT AS SPECIFIED HEREIN. REFER ALL SERVICING NOT SPECIFIED IN THIS MANUAL TO QUALIFIED SERVICE PERSONNEL. Failure to follow this WARNING may result in death or serious injury.
Introduction
Connecting your TV
CAUTION: HOT SURFACE
The temperature of the lamp immediately
after use exceeds 392ûF (200ûC). Touching the lamp before it has cooled will result in severe burns. ALLOW THE LAMP TO COOL FOR AT LEAST ONE (1) HOUR BEFORE REPLACING IT.
3. On the lamp unit door on the side of the TV, loosen the thumb screw by hand or by using a 5/32Ó or 4mm Allen wrench, and then remove the lamp unit door.
TV backThumb screw
Lamp unit door detail
WARNING: RISK OF
ELECTRIC SHOCK! The lamp
unit door is provided with an interlock to reduce the risk of electric shock and excessive ultraviolet radiation. Never defeat its purpose or attempt to service without removing the lamp unit door completely. Failure to follow this WARNING may result in death or serious injury.
4. Using a manual Phillips screwdriver, loosen the two screws on the lamp unit.
Lamp unit screws(Continued on next page)
61 | 5/10/05, 12:39 PM |
Black
Using the remote control
Setting up your TV
Features
Using the TVÕs
Appendix
Index
61
(E) 46/52/62HMX85