Toshiba 65H14 owner manual Adding channels to the TV’s memory, Programming channels automatically

Adding channels to the TV’s memory

When you press Channel		or , your TV will stop only on the	Note:
	y	z
channels stored in the TV’s channel memory.			To tune the TV to a channel not programmed
Follow the steps below and on the next page to program all active			in the channel memory, you must use the

channels into the TV’s memory.	Channel Number buttons on the remote
	control.

Programming channels automatically

Your TV can automatically detect all active channels in your area and store them in its memory. After the channels are stored automatically, you can manually add or erase individual channels (see page 25).

To program channels automatically:

1.Press MENU, and then press x or • until the SET UP menu appears.

2.Press y or z until the TV/CABLE is highlighted, and then press ENTER to display the pull-down menu.

3.Press y or z to highlight either TV or CABLE, depending on which you use. If you use an antenna, highlight TV; if you use cable, highlight CABLE.

TV/VIDEO RECALL POWER

INFO

1 2 3

4 5 6

7 8 9

+10CHRTN

100 0 ENT

Setting tup your TV

LANGUAGE	SET UP
	TV
CLOCK SET	CABLE
ANT 1 / 2
TV / CABLE
CH PROGRAM
ADD / ERASE
: SELECT	ENTER : SET

4.Press ENTER.

5.Press z to select CH PROGRAM.

	SET UP
LANGUAGE		ENGLISH
CLOCK SET		0 0 : 0 0
ANT 1 / 2		ANT1
TV / CABLE		CABLE
CH PROGRAM
ADD / ERASE		ADD

			N					G
			E	U	FAV			UI
		P	M	ORITE			PIC	D
	O								E
T							SI
			FAV
								ZE
					MENU
					DVDMENU
NENTER							EXIT			R
		T
E									EA
		E			FAV
			R					L
								C
	TV				CH	VOL
	CBL/SAT
	VCR
	DVD
				POP DIRECT CH MUTE			SLEEP
TV/VCR					PAUSE	STOP	PLAY
					FREEZE	SOURCE	SPLIT
		REW			FF	SKIP/SEARCH
CH SCAN					SWAP	POP CH

RECLIGHT

MENU

yzx •

ENTER Channel yz

: MOVE ENTER : START

6.Press ENTER to start channel programming. The TV will automatically cycle through all the TV or Cable channels (depending on which you selected), and store all active channels in the channel memory.

While the TV is cycling through the channels, the message “Programming Now—Please Wait” appears.

7.When channel programming is complete,the message “Completed” appears.

8.Press Channel y or z to view the programmed channels.

24