Toshiba 65H93 Completing the Quick Connect Guide assisted setup, Important final setup steps

Chapter 5: Quick Connect Guide & TV Guide On Screen setup

Completing the Quick Connect Guide assisted setup

The following screen appears. Highlight NEXT and press

ENTER.

Quick Connect Guide

Please connect as follows:

For advanced connection, please see owner’s manual.

From CABLE or ANTENNA -----		> ANT 1 TV
	Back		Next

Note: The text on this screen may vary, depending on your specific device connection.

Configuring the ANT 1 input source

Highlight your ANT 1 input source—antenna or Cable— and press ENTER.

Quick Connect Guide

Please select your source.

Antenna Cable

Programming channels into the channel memory

Press ENTER to start automatically programming all active channels (for the current input source) into the TV’s channel memory. This will enable you to use the

CH yz buttons on the remote control or TV front panel to change channels.

• For details on channel programming, see page 44..

Quick Connect Guide	i	ANT 1 Cable
Your TOSHIBA TV can memorize all available TV		Scanning channels, please wait...
				0%
channels automatically.
Press ENTER to start			Abort

Selecting the picture mode

Highlight the picture mode you prefer, and then press

ENTER.

• For details on the picture modes, see page 72.

Quick Connect Guide

Please select your favorite Picture Mode.

Sports: Bright & dynamic

STANDARD: Normal TV picture

MOVIE: Movie-like

Sports Standard Movie

Adjusting the color convergence

Press the TOUCH FOCUS button on the TV front panel to start automatic color convergence

• For details on adjusting the color convergence, see page 50.

Quick Connect Guide

Please push the TOUCH FOCUS button on the front panel. The TV will automatically adjust the convergence of the three picture tubes. It is best to repeat this process whenever the picture appears unclear.

Back Next

Completing the Quick Connect Guide setup

Highlight END and press ENTER to exit the Quick Connect Guide.

Quick Connect Guide

Basic setup has been completed.

Thank you.

Back End

Back

Next

Important final setup steps

When you have completed the Quick Connect Guide setup process, follow these steps so your TV can receive TV Guide On Screen program data as quickly as possible (otherwise, it may take up to 24 hours for the TV to receive program data).

1.Turn OFF your TV overnight.

2.If you have a Cable box connected, leave it ON.

3.If you have a VCR connected, turn it OFF.

4.If you have more than one Cable system in your area, you may be prompted to select which Cable system’s program data to download. If so prompted, follow the on-screen instructions.

40 Copyright © 2003 TOSHIBA CORPORATION. All rights reserved.