Satellite A660/A660D, Satellite A665/A665D

Sleep and Charge function

For more information and settings, please refer to the Using the TOSHIBA Sleep Utility section in Chapter 4, Operating Basics.

Problem

Procedure

I cannot use the

Sleep and Charge function may be disabled.

“Sleep and Charge

Select the “Enable Sleep and Charge” check box

function”.

in the TOSHIBA Sleep utility to enable this

 

function.

 

 

 

When there is a current overflow of the external

 

device connected to the compatible port, USB

 

bus power (DC5V) supply may be stopped for

 

safety reasons. When this happens, disconnect

 

an external device if some external devices are

 

connected. After that, turn the power of the

 

computer ON/OFF to restore the function. If this

 

function can not be still used even if only one

 

external device is connected, stop using the

 

external device because its current is over the

 

acceptable value of this computer.

 

 

 

Some external devices may not be able to use

 

the “Sleep and Charge function”. In this case,

 

please try one or more of the following methods.

 

■ Select another mode.

 

■ Turn OFF the computer while external

 

devices are connected.

 

■ Connect external devices after turning OFF of

 

the computer.

 

If this function can not be still used, change the

 

setting to disable the function and stop using this

 

function.

 

 

The battery depletes

If Sleep and Charge function is enabled, the

quickly even when I

computer’s battery will discharge during

turned OFF the power

hibernation or when the computer is turned off.

of the computer.

Connect the AC adaptor to the computer or

 

disable the Sleep and Charge function.

 

 

User’s Manual

8-17