Using the Remote Control

To control a cable TV converter:

Program the remote control to recognize the brand of your converter (see “Programming the remote control for use with a VCR or cable TV converter,” below). The shaded buttons shown on the right will control the cable TV converter.

Set the TV/CABLE/VCR switch to the CABLE position.

Programming the remote control for use with a VCR or a cable TV converter

This remote control is pre-programmed to operate Toshiba VCRs. To use VCRs or cable converters other than Toshiba models, you must follow the steps below before you operate your remote control.

1.Refer to the “VCR code table” or “Cable TV converter code table” on pages 9-10 to find the number that corresponds to the brand name of your VCR or converter.

If more than one number is listed, try each one separately until you find the one that works.

2.If you are reprogramming the remote control to operate your:

•VCR, set the TV/CABLE/VCR switch on the remote control to VCR.

•cable converter, set the TV/CABLE/VCR switch on the remote control to CABLE.

3.Hold down the RECALL button while using the Channel Number buttons to enter the three-digit code number of your brand of VCR or converter.

4.Point the remote control at the VCR or converter and press POWER to test the code number.

If the VCR or converter turns on, you have entered the right number.

If the VCR or converter does not respond to the remote control, you may have entered the wrong number. Repeat steps 1-4 with another code number.

For future reference, write down the code numbers you used:

VCR code

_____________________

Cable code

_____________________

 

LIGHT RECALL

POWER

 

POWER

TV

 

 

 

 

 

CABLE

MUTE TV/VIDEO TIMER

VCR

 

 

 

1

2

3

 

 

 

 

CH

4

5

6

Channel

 

 

 

7

8

9

Number

 

 

CH RTN

VOL

100

0 ENT

Enter

 

ADV/

 

 

.CAPT

PIP CH

MENU

 

C

 

 

 

FAV

ENTER

 

FAV

RESET

ADV/

 

EXIT

 

 

 

PIP CH

 

 

STOP SOURCE

PLAY PIP

Note:

•Each time you replace the batteries, you must reprogram the remote control.

•Some newer VCRs are capable of working on either of two remote codes. These VCRs have a switch labeled “VCR1/VCR2.” If your VCR has this kind of switch, it may not respond to any of the code numbers for your VCR brand name. In this case, set the switch to the other position (VCR1 or

VCR2) and reprogram the remote control.

8