Learning operating code of another remote controller
This remote control is capable of learning operating codes from most infrared remote controllers. You can control the functions of your TV and a variety of video/audio equipment with the supplied remote control only.
The 21 buttons marked with 
can be used as the Learning buttons.
1.Set the TV/CABLE/VCR/AUX switch to “AUX” position.
2.Place the supplied remote control and the remote controller to be learned, head to head approximately 1 to 3 inches (3 to 8 cm) apart.
LIGHT RECALL POWER
TV CABLE
VCR MUTE TV/VIDEO TIMER 
AUX
1 | 2 | 3 |
Learning indicator
RECALL
Introduction
Connecting your TV
4 | 1 | TV CABLE VCR AUX |
|
5 | 2 | MUTE | LIGHT |
6 | 3 | TV/VIDEO | RECALL |
| CH | TIMER | POWER |
Supplied Remote Control
Head to head
POWER | 3 | 6 | 9 |
| 2 | 5 | 8 |
| 1 | 4 | 7 |
TV/VCR |
|
|
|
Remote controller to be learned
|
|
| CH | |
4 | 5 | 6 |
| |
7 | 8 | 9 |
| |
|
| CH RTN VOL | ||
100 | 0 | ENT |
| |
|
| ADV/ |
| |
FAVORITE | PIP CH | STROBE | ||
|
| |||
|
|
| ||
FAV | MENU/ | FAV | ||
ENTER | ||||
|
| |||
MENU/ENTER
Using the Remote Control
3.Hold down RECALL and MENU/ENTER at the same time to enter into the learning mode. The learning indicator will blink.
4.Hold down the Learning button (marked 
) on the supplied remote control until the learning indicator lights up.
When you press a button other than a Learning button, the indicator will blink. (The button you pressed is not a Learning button.)
5.Hold down the button of the function to be learned on the other remote controller for about 3 seconds until the learning indicator starts blinking.
Note: If the learning indicator blinks rapidly, the supplied remote control cannot learn the operating code or an error has occurred.
Try steps 4 and 5 again.
6.Repeat steps 4 and 5 for storing other functions into other buttons.
7.Press EXIT to release the learning mode.
8.To check your programming, operate the appropriate equipment with the supplied remote control. If the equipment does not operate as expected, repeat steps 1 to 7.
If necessary, try changing the distance between the two remote controllers.
9.Reset the TV/CABLE/VCR/AUX switch to “TV” position to control the TV.
PREVIEW | ADV/ | EXIT | |
| PIP CH |
| |
STOP SOURCE | PLAY PIP | ||
REC | TV/VCR | REW | FF |
| STILL | LOCATE | SWAP |
EXIT
Setting up your TV
Using the TV’s Features
Appendix
Index
15