4. Operation
CAUTION
Failure to take the opportunity to discover abnormalities can result in injuries and equipment damage. Always check to make sure that the ON and OFF indicators are correct before operating the equipment.
4.1 Manual Operation
CAUTION
To avoid damaging the equipment, do not close the circuit when the unit switching indicator is ON.
4.1.1 Closing the Circuit
Check to make sure that the switching status is set to OFF.
4.1.1.1 For Motorized
Attach the handle using the steps shown in Figures 11 and 12, in that order.
The manual charging handle shall be applied for emergency case and maintenance purpose only, remove (not install) the handle at normal service condition.
Figure 11 Attach the handle provided with the unit to the handle shaft. Check to make sure that the handle has been securely connected to the shaft (small screw M5).
Figure 12 Using the small screw (M5) provided, fasten the handle in position. The tightening torque should be 2.94 to 3.92
- 16 -
