16
Status LED
The LED indicates the status of the Network Camera.
RESET ETHERNET DC IN 12A
Recessed Reset Button
Status LED
Hardware Reset
The reset button is used to reset the
system or restore the factory default
settings. Occasionally resetting the
system can return the camera to
normal operation. If the system
problems remain after resetting restore
the factory settings and install again.
Reset:Hold for about 2 seconds and
release the recessed reset button with
a paper clip or small object. Wait for
the Network Camera to reboot.
Restore:Press and hold the recessed
reset button until the status LED
rapidly blinks. It takes about 30
seconds. Note that all settings will
be restored to factory default. Upon
successful restore, the status LED will
blink during normal operation.
Restoring the factory defaults will erase any previous settings.
Item LED status Description
1All LED lit=> All LED unlit=> Steady Red =>
Steady Red + Blink Green once per sec. System booting
2 Steady Red Power on; Network fail
3 Blink Green every 1 sec. Network works
4 Blink Orange/ Yellow every 0.15sec Upgrading F/W
5 Blink Red every 0.15sec Restore default
6Press the reset button until all LEDs blink fast
(0.15sec/time), then release the reset button Reset button for reset