Toshiba L450, L450D manual LAN

L450/L450D

Problem	Procedure
No display	Try adjusting the contrast and brightness controls
	on the external monitor.
	Press the FN + F5 hot key in order to change the
	display priority and ensure that it is not set for the
	internal display panel only.
	Check to see if the external monitor is connected.
	When the external monitor is set as the primary
	display device in extended desktop mode, it will
	not display when the computer wakes up from
	Sleep Mode if the external monitor has been
	disconnected while in Sleep Mode.
	To keep this from happening, do not disconnect
	the external monitor while the computer is in
	Sleep or Hibernation Mode.
	Remember to turn off the computer before
	disconnecting the external monitor.
	When the display panel and an external monitor
	are set to clone mode and the monitors are
	turned off by the timer, the display panel or the
	external monitor may not display when turned on
	again.
	If this occurs, press FN + F5 to re-set the display
	panel and external monitor to clone mode.
Display error occurs	Check that the cable connecting the external
	monitor to the computer is firmly attached.
	If you are still unable to resolve the problem,
	contact your reseller, dealer or service provider.

LAN

Problem	Procedure
Cannot access LAN	Check for a firm cable connection between the
	LAN jack and the LAN HUB.
Wake-up on LAN does	Make sure the AC adaptor is connected. The
not work	Wake-up on LAN function consumes power even
	when the system is off.
	If problems persist, consult your LAN
	administrator.

9-18 User’s Manual