Hardware, Utilities and Options

12.Tuck the keyboard ribbon cable into the groove under the memory module cover.

Memory module cover

Screws

Keyboard ribbon cable

Figure 3-9 Seating the memory module cover

13. Insert the tabs on the front of the keyboard into the corresponding notches on the computer and place the keyboard down.

When seating the keyboard, be sure to connect the circuit board if the keyboard ribbon cable was pulled out while you were removing the keyboard.

14. Replace the keyboard and secure it using the two screws.

Be sure to use all two screws removed in step 7. Make sure no screw was dropped into the computer. Make sure no foreign matter can be found inside the computer.

Keyboard

Screws

Tabs

Figure 3-10 Replace the keyboard

15.Set the keyboard brace into its groove and hold down to secure the latches.

16.Install the battery pack. Refer to Replacing the battery pack section in Chapter 6, Power and Power-Up Modes, for details.

17.Turn your computer over.

18.Turn the computer on and make sure the added memory is recognized - to confirmed it, Start -> Control Panel -> System and Maintenance - > System icon.

User’s Manual

3-21