Operating Basics

Changing Ultra Slim Bay modules

This section explains how to change modules in the Ultra Slim Bay. The illustrations show replacement of the optical disc drive with the Ultra Slim Bay HDD Adaptor. Therefore, the text refers to those modules. However, the procedures are the same for any of the modules: DVD Super Multi drive and HDD adaptor.

To avoid injury, do not put your hand into the Ultra Slim Bay slot.

Removing a module

Remove the optical disc drive as described below.

1.You can confirm that the disks are not operating with indicators. If all indicators are off, it means that no disks are operating currently.

2.Turn the computer upside down.

Wait for all disk indicators to go out before you turn over the computer and do not lay the computer down gently. Shock can damage the HDD or other components.

3.Remove the Ultra Slim Bay lock screw from the Lock position.

4.Set the Ultra Slim Bay lock screw in the Unlock position.

5.Slide the Ultra Slim Bay latch to the unlock position.

6.Grasp the optical disc drive and slide it out.

The optical disc drive and other Ultra Slim Bay modules can become hot with use. Be careful when removing the module.

Ultra Slim Bay latch

Lock screw (Unlock position)

Lock position

Optical disc drive

Figure 4-4 Removing the optical disc drive

User’s Manual

4-10