the 2 self tapping screws on the back panel.
7.Remove the top portion of the shield and set it aside.
8.Unclip the wires leading to the power supply.
9.Lift the main board and remove the bottom portion of the shield. Then rest the main board in the
10.Align the notch in the board with the bottom of the
11.Before unplugging the flex cables, the laser pickup must be shorted to prevent static damage to the laser.
12.To access the laser pc board, remove the safety shield covering the laser assembly.
13.Remove the 2 screws holding the disc clamp and lift it off the laser assembly.
14.Cut the cable tie that holds the power supply cable to the cross bracket.
15.Remove the 2 screws holding the cross bar and lift the cross bar off the player.
16.Remove the 2 screws holding the disc tray in the player.
17.Pull the tray out of the player.
18.Carefully solder the pad with a small tipped soldering iron.
19.Remove the main board by gently unplugging the flex cables and the power supply connec- tor.
20.Lift the main board out of the holders.
2
21.Remove the 4 screws holding the power supply.
22.Lift the power supply board out of the cabi- net.
23.Remove the 3 screws holding the laser me- chanical assembly.
24.Lift the assembly out of the cabinet.
25.Remove the component video output board by retracting 2 screws on the back of the cabinet.
26.Remove the front panel by retract 4 screws, 1 on each side and 2 on the top.
27.Releasing the tabs and pull the panel away from the cabinet.
28.The front panel circuit boards are remove by retracting 6 screws,.and lifting the circuit boards out of the front panel.
LASER DISASSEMBLY
1.Unplug the flex cable attached to the laser slide assembly.
2.Remove the 4 screws and washers holding the laser slide assembly in place.
3.Lift the laser slide assembly out and set it aside.
4.Retract 2 screws at the rear of the mechanical assembly.
5.Remove the lift assembly.
6.Remove the loading motor by first taking off the loading belt.
3
