When an obstacle stands between the infrared receiver window of
your computer and the Remote Controller.
When direct sunlight or strong fluorescent light strikes the infrared
receiver window.
When the infrared receiver window or the infrared emission part of the
Remote Controller is dirty.
When other computers which use an infrared remote controller are
used near to your computer.
When a low battery condition is present.
Replacing the battery
When the battery shipped with the Remote Controller is discharged,
replace it with commercially available CR2025 battery. Other types of
battery should not be used.
Store the battery for the remote control beyond the reach of children. If a
child swallows a battery, this might result in choking. If it happens, contact
a doctor immediately.
Observe the following precautions when using the battery of the Remote
Controller.
Do not use battery other than those specified.
Ensure that you insert the battery with its polarities correctly aligned (+
or -).
Do not recharge, heat, disassemble or short the battery, or put it into a
fire or flame.
Do not use a battery whose "recommended expiration date" has been
reached, or which is completely discharged.
Do not carry the battery together with metal necklaces, hairpins or
other metal accessories.
When storing or disposing of used batteries, make sure to put some
insulation tape on their terminals (+ and -) to avoid short-circuits.
If these precautions are not followed, heating, fluid leakage or explosion
may occur. This may cause burns or personal injury. If battery fluid gets on
your skin or clothes, wash immediately with clean water. If battery fluid gets
in your eyes, rinse your eyes with clean water immediately and see a
doctor. Do not touch the battery fluid on instruments or devices with bare
hands. Wipe off with a cloth or paper towel.
1. Press and hold the battery tray lock on the under side of the remote
controller, and then pull the battery tray as shown below.
User's Manual 4-10