Setting up HDD Protection

You can change HDD Protection settings.

To open the utility, click Desktop Assist -> Tools & Utilities -> System Settings -> HDD Protection on the desktop. The utility can also be started from the icon on the Windows Taskbar or from the Control Panel.

HDD Protection

You can enable or disable HDD Protection by moving the slider to the right or left.

HDD Protection does not work when the computer is booting, in Sleep Mode, in Hibernation Mode, in transition to Hibernation Mode, recovering from Hibernation Mode, or powered off. Do not subject the computer to vibration or impact while the protection is disabled.

HDD Protection Message

Move the slider to the right to enable notification when viberation is detected.

System Tray Icon

Move the slider to the right to show HDD Protection icon on the Windows Taskbar.

There are the following conditions for HDD Protection icon.

Normal

TOSHIBA HDD Protection is enabled.

 

 

Protection

TOSHIBA HDD Protection is active. The hard

 

disk drive head is in a safe position.

 

 

OFF

TOSHIBA HDD Protection is disabled.

Detection Level

There are four sensitivity levels in which vibrations, impacts and their similar signs are detected can be set to OFF, 1, 2 and 3 in ascending order. Level 3 is recommended for better protection of the computer.

However, when the computer is used in a mobile environment or in other unstable conditions, setting the detection level to 3 could result in frequent execution of HDD Protection, which will slow down Hard Disk Drive reading and writing. Set a lower detection level when the speed of Hard Disk Drive reading and writing is a priority.

User's Manual

5-21

Page 110
Image 110
Toshiba P50t-B Series, P50-B Setting up HDD Protection, HDD Protection Message, System Tray Icon, Detection Level