Toshiba Battery, DC IN, Battery, Problem, Battery, Battery, Battery, Select a, Procedure, Power saver, power plan in the Power Options

L500/L505/L500D/L505D

Battery

If you suspect a problem with the battery, you should check the status of the DC IN indicator as well as the Battery indicator. Please refer to Chapter 6, Power and Power-up Modes, for more information on these indicators, together with general battery operation.

Problem	Procedure
Battery doesn’t power	The battery may be discharged - connect the AC
the computer	adaptor to recharge the battery.
Battery doesn’t	If the battery is completely discharged, it will not
charge when the AC	begin charging immediately, in these instances
adaptor is attached	you should wait a few minutes before trying again.
(Battery indicator	If the battery still does not charge, you should
does not glow	check that the power outlet to which the AC
amber).	adaptor is connected is supplying power - this can
	be tested by plugging another appliance into it.
	Check whether the battery is hot or cold to the
	touch - if so, it will not charge properly and should
	be allowed to reach room temperature before you
	try again.
	Unplug the AC adaptor and remove the battery to
	make sure its connecting terminals are clean - if
	necessary wipe them with a soft dry cloth lightly
	dipped in alcohol.
	Connect the AC adaptor and replace the battery,
	taking care to ensure that it is securely seated in
	the computer.
	Check the Battery indicator - if it does not glow,
	allow the computer to charge the battery for at
	least twenty minutes. If the Battery indicator
	starts to glow after this period, allow the battery to
	continue to charge for at least another twenty
	minutes before turning on the computer. However,
	if the indicator still does not glow, the battery may
	be at the end of its operating life and should be
	replaced. However, if you do not believe the
	battery is at the end of its operating life, you
	should speak to your reseller, dealer or service
	provider.
Battery doesn’t power	If you frequently recharge a partially charged
the computer as long	battery, the battery might not charge to its full
as expected	potential - in these instances you should fully
	discharge the battery and then attempt to charge
	it again.
	Check the Power saver option under Select a
	power plan in the Power Options.

9-6 User’s Manual