4 Replacement Procedures 4.16 Switch board
4-40 [CONFIDENTIAL] QOSMIO G30 Maintenance Manual (960-546)
Installing the Switch board
The following describes the procedure for installing the switch board (See Figure 4-23).
1. Connect the switch cable to the connector CN9660 on the switch board.
2. Install the reinforcing plate and switch board to the cover assembly while passing
the switch cable through the hole of reinforcing plate and secure them with the
following screws.
• M2.5×6S Tapping screw ×2
3. Stick the glass tape B in place.
4. Pass the cables on the reinforcing plate and stick the glass tape A on it.