OWNER,S MANUAL - 8
BEFORE OPERATION
REMOTE CONTROL DESCRIPTION
Names and Functions of the Buttons
1 ON/OFF BUTTON
A 
SWING
A
ON/OFF | SLEEP |
TEMP.
| MODE |
| FAN | FLAP |
|
|
|
| |
CLOCK | EVERYDAY HOUR | MINUTE | ||
| ||||
TIMER | RESERV. CANCEL | |||
ON | OFF | |||
RST TA
If you press this button, the unit will begin operation. Press the button again, and operation stops. ( You can hear a receiving beep. ) If you press this button immediately after turning off the unit, the compressor will not operate for 3 minutes to prevent overloading.
2 TEMPERATURE SETTING BUTTONS
If you set the desired room temperature, then the unit will maintain the room temperature as set . In COOL mode, if the room temperature is higher than the setting, the compressor will automatically turn on to provide a cooling effect. On the other hand, if the room temperature is lower than the setting, the compressor will automatically turn off to stop cooling operation. In HEAT mode, if the room temperature is lower than the setting, the compressor will automatically turn on to
provide a heating effect. If the room temperature is higher than the setting, the compressor will automatically turn off to stop heating operation. However,the indoor fan will continue
to circulate air even if the compressor is turned off.
3 SLEEP TIMER BUTTON
Press this button to set the SLEEP timer. (Refer to p.19)
4 OPERATION MODE SELECTING BUTTON
Press this button to select the desired mode.
In AUTO mode, the unit will run automatically by selecting
COOL or HEAT mode according to the indoor room temperature. In DRY mode, the microcomputer of the unit controls the indoor fan motor and makes the outdoor unit automatically turn on and off according to the room temperature, which causes moisture to be removed more effectively.
In COOL mode, the unit will run at the normal cooling mode. In FAN mode, only the indoor fan will operate at the selected fan speed and circulate room air. In HEAT mode, the unit will run at the normal heating mode.
