Simple wired remote controller Owner’s Manual
–6–
EN
3HOW TO OPERATE INDOOR UNIT

COOL/HEAT AUTO ,

HEAT , DRY ,

COOL , FAN

Power supply
Turn on the power supply switch
12hours before starting operations.
After the power supply has been
turned on, the operation of the remote
controller is not accepted for
approximately 1minute. It is not a
failure.
(The sensor receives the signal once,
but the received contents are cleared.)
1Push (ON/OFF) button.
2Push (Mode) button to select
operation to , , , or
.
3Push (Fan Speed) button to
select fan speed mode.
When selecting , fan speed is
automatically changed.
(During FAN mode, the fan speed is
not automatically changed.)
4Push either or to select
a desired temperature.
During FAN mode, the temperature
cannot be set up.
5Stop
Push , (ON/OFF) button.
When using the remote controller to
stop the unit, the outdoor unit fan
may keep operating for a while even
if the compressor of the outdoor unit
has stopped.
In heating, if the room is not
comfortably heated with FAN ,
select FAN or .
Although they are displayed, the
function may not be provided
depending on the using indoor unit.
(Fan speed is constant.)
When the unit cannot be stopped
by the normal operation.
Turn off the power switch or circuit
breaker, and then contact the shop
which you purchased the unit.
3
2
1
5
4
6-EN
+01EN.BOOK Page 6 Thursday, October 8, 2009 3:37 PM