Toshiba RD-XS34SC Preparation of the remote control, Open the cover Insert batteries AAA size

Introduction

Preparation of the remote control

1 Open the cover.

2 Insert batteries (AAA size).

Make sure to match the + and – on the batteries to the marks inside the battery compartment.

3 Close the cover.

Caution

•Never throw batteries into a fire.

Notes

•Dispose of batteries in a designated disposal area.

•Attention should be drawn to the environmental aspects of battery disposal.

•Do not mix different battery types or combine used batteries with new ones.

•If the remote control does not operate correctly, or if the operating range becomes reduced, replace both batteries with new ones.

•If the batteries are dead or if you will not be using the remote control for a long time, remove the batteries to prevent battery acid from leaking into the battery compartment.

Operating with the remote control

Point the remote control at the remote sensor and press the buttons.

30° 30°

Within about 7 m (23 ft)

Distance : About 7 m (23 ft) from the front of the remote sensor

Angle : About 30° in each direction of the front of the remote sensor

*Do not expose the remote sensor of the recorder to a strong light source such as direct sunlight or other illumination. If you do so, you may not be able to operate the recorder via the remote control.

Notes

•Do not drop or give the remote control a shock.

•Do not leave the remote control near an extremely hot or humid place.

•Do not spill water or put anything wet on the remote control.

•Do not disassemble the remote control.

18