Function setup
Multi brand remote control
The remote control can be compatible with various brands of TV by setting their control codes. The TOSHIBA code has initially been set to control TOSHIBA TVs.
Setting TV control codes
POWER INPUT SELECT
100 DISPLAY
PROGRAM ENTER
1 Press TV to set the remote control operating your TV.
2 While holding down PROGRAM enter the two digits of your TV's brand code (listed below) using number buttons
PROGRAM.
Point the remote control at your TV and use each button listed berow to make sure that your TV is operated correctly.
POWER | To turn the TV on or off. |
CH +/– | To select TV channels in the upper |
| or lower direction. |
VOL +/– | To adjust the sound level. |
INPUT SELECT | To select an external source such |
| as a VCR. |
Number buttons | To select TV channels. When select- |
ing channels 1 to 9, first enter 0 and | |
| then desired number. |
100 | To substitute for 100 channel key. |
DISPLAY | To turn on or off TV’s screen dis- |
| play. |
ENTER | To use for the TV’s ENTER key. |
Important
Some TV’s may not respond to all the operations left, or may not be operated at all with this remote control. In this case, operate your TV with its own remote control.
Notes:
•For some brands, several control codes (brand codes) are al- located. Try each of them until the buttons work on your TV.
•If you replace the remote control’s batteries, set the brand code again.
Table of TV brand codes
Brand No. | TV Brand | Brand No. | TV Brand | Brand No. | TV Brand |
|
|
|
|
|
|
01 | TOSHIBA | 07 | PANASONIC | 13 | SHARP (old) |
|
|
|
|
|
|
02 | RCA / GE | 08 | SHARP (New) | 14 | ZENITH |
|
|
|
|
|
|
03 | SONY | 09 | SANYO (FISHER) | 15 | PANASONIC |
|
|
|
|
|
|
04 | MITSUBISHI | 10 | MAGNAVOX | 16 | PIONEER |
|
|
|
|
|
|
05 | JVC | 11 | GOLDSTAR |
|
|
|
|
|
|
|
|
06 | HITACHI | 12 | SAMSUNG |
|
|
|
|
|
|
|
|
40
2C01501A | 40 | 12/16/03, 19:59 |
