Toshiba SD-KV540SU owner manual Optional TV Connections, Audio Connection for DVD, Preparation

Connections (Continued)

RF coaxial connection

Connect the RF.OUT jack on the DVD+VCR to the antenna in jack on the TV using the supplied 75-ohm Coaxial Cable (R).

How to set the DVD+VCR’s RF output channel

1.When the DVD+VCR is turned off, press and hold CH (V/v) on the front panel for more than five sec- onds. “RF03” or “RF04” appears in the display win- dow.

2.Press CH (V/v) to change the RF output channel (RF03 or RF04). Tune the TV to this channel.

3.Turn off the DVD+VCR.

Audio/Video connection

1.Connect the DVD/VCR VIDEO OUT jack on the DVD+VCR to the video in jack on the TV using the video cable supplied (V).

2.Connect the Left and Right DVD/VCR AUDIO OUT jacks on the DVD+VCR to the audio left/right in jacks on the TV (A1) using the supplied audio cables.

Note:

If you use this connection, set the TV’s source selector to

VIDEO.

Component Video (ColorStream®) / Progressive Scan (ColorStream Pro®) connection

If your television is a high-definition or “digital ready” tel- evision, you may take advantage of the DVD+VCR’s progressive scan output for the highest video resolution possible.

1.Connect the COMPONENT/PROGRESSIVE SCAN VIDEO OUT jacks on the DVD+VCR to the corre- sponding in jacks on the TV using an

optional Y Pb Pr cable (C).

2.Connect the Left and Right AUDIO OUT jacks of the DVD+VCR to the audio left/right in jacks on the TV using the supplied audio cables (A2) .

Notes:

•Set the Video Output to “YPbPr” and Progressive Scan to “On” on the setup menu for progressive scan signal, see page 18.

•When you use Component Video signal, set the Progressive Scan to “Off” on the setup menu.

•Progressive scan does not work with the analog video connections (yellow VIDEO OUT jack and S-VIDEO OUT jack).

•Do not use Component Video jacks and S-VIDEO jack at the same time, the picture quality will be poor.

•If your TV does not accept the Progressive Scan format, the picture will appear scrambled.

PREPARATION

Optional TV Connections

These connections support only DVD playback. The tuner and VCR can only output through the RF.OUT (R) or DVD/VCR OUT (A, V) jacks.

S-Video connection

1.Connect the S-VIDEO OUT jack on the DVD+VCR to the S-Video in jack on the TV using the optional S-Video cable (S).

2.Connect the Left and Right AUDIO OUT jacks of the DVD+VCR to the audio left/right in jacks on the TV using the supplied audio cables (A2).

Note:

Set the Video Output to “S-VIDEO” on the setup menu for S-VIDEO signal, see page 18.

Audio Connection for DVD

You can only listen to DVD playback using COAXIAL

(X)and AUDIO OUT (A2) connections. The tuner and VCR can only be heard through the RF.OUT (R) or DVD/VCR AUDIO OUT (A1) jack. (See page 12.)

Connecting to an amplifier equipped with two chan- nel analog stereo or Dolby Pro Logic II/Pro Logic

Connect the Left and Right AUDIO OUT (or DVD/VCR AUDIO OUT) jacks on the DVD+VCR to the audio left and right in jacks on your amplifier, receiver, or stereo system using the audio cables (A1, A2) supplied.

13