Audio Cable (optional) - If you have a sound card and speakers, and would like to play audio CDs on your computer, you will need to get a sound cable. Contact AMC, our small parts supplier, at 888/262-9700. Sound cables are made for the sound card you are using and the DVD- RAM to which you are connecting. Make sure you have this information when purchasing a sound cable. The sound cable connects to your sound card at one end and the other end connects to the digital audio connector at the left rear of the DVD-RAM
(see DVD-RAM Back Panel photo on page 6 for location). Refer to the instructions which came with your sound card for details on any sound-driver software required. Also refer to the REALmagic Hol- lywood+ User’s guide for addi- tional audio connection options.
COMPLETING INSTALLATION
After you have connected all the necessary cables, push the DVD-RAM completely into the computer’s drive slot. Mount drive according to your computer’s instructions. The screw length should not exceed 3±0.5mm (measured from outside surface of side or bottom of DVD-RAM to tip of screw). Replace computer cover and all outer screws.
Mounting Screw
M3
Mounting frame of host computer
Surface of side or bottom of DVD-RAM drive
2.5 - 3.5mm
Software Driver: A DVD-RAM software driver must be installed in your system for your computer to recognize the DVD-RAM drive. You may also be required to install software that was provided with your DVD/ MPEG card.
INSTALLING DVD-RAM SOFTWARE “W RITE DVD” ( INCLUDED
IN KIT)
1.Insert “Write DVD” diskette into your A: drive.
2.Go to Start/Run and type A:\setup.exe and press OK.
3.Software driver will be installed.
4.Reboot your system
