Introduction
Identification of Controls (continued)
Loading batteries | Operating with the remote control | |||
1 | Open the cover. | Point the remote control at the remote | ||
| sensor and press the buttons. | |||
|
|
|
|
|
|
|
|
|
|
2 Insert batteries (R03/AAA size).
Distance: About 7 m (23 feet) from the front of the remote sensor
Angle: About 30° in each direction of the front of the remote sensor
* Do not expose the remote sensor of the DVD player to a strong light source such as direct sunlight or other illumination. If you do so, you may not be able to operate the DVD player via the remote control.
Make sure to match the + and – on the batteries to the marks inside the battery compartment.
Caution
Never throw batteries into a fire.
Notes
•Be sure to use R03/AAA size batteries.
•Dispose of batteries in a designated disposal area.
•Batteries should always be disposed of with the environment in mind. Always dispose of batteries in accordance with applicable laws and regulations.
•If the remote control does not operate correctly, or if the operating range becomes reduced, replace both batteries with new ones.
•When necessary to replace batteries in the remote control, always replace both batteries with new ones. Never mix battery types or use new and used batteries in combination.
•Always remove batteries from remote control if they are dead or if the remote control is not to be used for an extended period of time.This will prevent battery acid from leaking into the battery compartment.
•Battery shall not be exposed to excessive heat such as sunshine, fire or the like.
Notes on the remote control
•Direct the remote control at the remote sensor of the DVD player.
•When using the remote control, press the buttons at intervals of about 1 second to ensure the correct mode of operation.
•Do not drop or give the remote control a shock.
•Do not leave the remote control near an extremely hot or humid place.
•Do not spill water or put anything wet on the remote control.
•Do not open the remote control.
10
