Installation Manual |
3 INSTALLATION METHODS
CAUTION
•Before installing the wind shield, change the air conditioner settings. Refer to “Changing the setting” on page 4.
•Unless the setting is changed, the air blow temperature becomes low. This may cause the dew condensation.
Installing the wind shield(s) and packings
•Attach the wind shields to the air flow openings (made of styrene foam) of the indoor unit and place the packings on them to block the air flow. (Refer to Fig. 1 to 3.)
•Put the packings bending along the edges of the indoor unit external surface without blocking the concaved portions of the drain pans. (If the packings are not put bending along the edge of the indoor unit external surface, the dew condensation may occur.) (Refer to Fig. 1 and 3.)
*The size adjustment is required for the packing which are attached on the wind shield C. Cut 1.58” (40 mm) to adjust its size in 16.5” x 4.3” (420 mm x 110 mm).
(Fig. 1) | (Fig. 2) |
Packing | Wind shield (A, B, C) Drain pan |
Packing
0.4” (10 mm)
Indoor unit External surface
Wind shield A Packing
Wind shield B
Wind shield A
Packing (required to cut 1.58” (40 mm.)
Wind shield C
Interior styrene foam | Air flow outlet |
(Fig. 3)
Put the packings without |
blocking the concaved |
portions. |
0.4” (10 mm) |
Drain piping
Refrigerant piping
EN |
– 2 – |