
16
Using the Projector
Using the On-Screen Menus
The projector has menus that allow you to make image adjust-
ments and change a variety of settings. These adjustments aren’t
available directly from the keypad.
NOTE: Some menu items may be
grayed out (dimmed) at certain
times. This indicates the item is
not applicable to your setup or the
item is not enabled until another
selection is made.
To open the on-screen menus, press the MENU button on the
keypad or remote. (The menus automatically close after 30
seconds if no buttons are pressed.) This displays the Main menu
and changes the SOURCE and RESYNC buttons on the keypad to
INCREMENT and DECREMENT buttons and the MENU button to a
SELECT button. Press the DECREMENT button to move the cursor
down and press the INCREMENT button to move the cursor up.
The selected menu is highlighted.
FIGURE 13
Main menu
To change a menu setting, use the INCREMENT and DECREMENT
buttons to move the cursor up and down to the item you want to
change (the selected item is highlighted), then press SELECT.
When an item is selected, its button appears depressed to provide
a visual indication of selection. Use the INCREMENT and DECRE-
MENT buttons to adjust the setting or turn it on and off. Press
SELECT when you are done. Press the INCREMENT and DECRE-
MENT buttons to move to another setting. When you have com-
pleted your adjustments, navigate to Exit, then press SELECT. You
are returned to the top of the Main menu. Press SELECT again to
exit the Main menu, or navigate to another submenu.