Note

The start-up screen will disappear after a moment. You can also configure the system to prevent the start-up screen from appearing. To do this, use the Default setting menu

p.36 .

The first time you use the projector after purchase, the language selection menu will be displayed.

Do not touch the lens directly with your hand. If fingerprints or stains are left on the projection lens surface, they may interfere with the projector's ability to project images on the screen.

„Turning the power off

Press the ON/STANDBY button.

A message appears on the screen, confirming that you wish to shut off the power. To shut off the power, press the ON/STANBY button again. If you do not wish to shut off the power, wait for a while without conducting any operations. The message will disappear shortly. (This operation is no longer valid after the message disappears.)

Press the ON/STANDBY button again.

The screen turns off, but the internal cooling fan continues to operate for a short while. Then, the projector goes into standby mode.

When cooling lamp

 

After cooling complete

 

 

 

 

 

 

During cooling, the ON/STANDBY and LAMP indicator flash. In this state, the power

cannot be turned back on.

However, there is no problem with unplugging the power cord in this state. In standby mode.

Note

The projector consumes about 8W of power in standby. We recommend that you unplug the power cord if you will not be using the projector for an extended period.

Precaution

If the power cord is unplugged before cooling is complete, give the lamp time (about 5 minutes) to cool before plugging it back in. If the lamp overheats, it may fail to light.

Operations

29

Page 29
Image 29
Toshiba TDP-PX10 „ Turning the power off Press the ON/STANDBY button, Press the ON/STANDBY button again, Precaution