Toshiba TDP-T95 manual Connecting a computer, Placement Styles, Operating a computer

a (max length) = projection size (inches) – 0.6246 16.749

a (min length) = projection size (inches) – 1.0437 26.957

, in accordance with your needs.

Operating a computer using the remote control

A computer can be operated using the projector’s remote control. This function is available on any computer with the Windows® 98/98SE, Windows® Me, Windows® 2000, or Win- dows® XP OS, that is equipped with a USB port which can support USB1.1 (The mouse remote control receiver is also supported on OS 9 or OS X for the Macintosh). However, please note that Toshiba does not guarantee the operation of all computers.

1Connecting a computer

Connect the mouse remote control receiver (supplied) to a computer.

Placement

Placement Styles

As shown in the figures below, this device can be placed in 4 different styles.

The factory setting is “floor-mounted front projection.” Set the [Projection mode] in the Default setting menu p.40

Floor-mounted front projection

To USB port

Mouse remote control receiver

The remote control may fail to operate if the mouse remote control receiver is exposed to bright sunlight or fluorescent lighting.

In such a case, change position or direction of the mouse remote control receiver and retry.

Preparations

2Operating a computer

Operate remote control’s buttons towards the mouse remote control receiver.

●Moving the mouse pointer

Press the mouse control button in the direction you wish the mouse pointer to move, then press.

●To left click

Press the L-CLICK button.

●To right click

Press the R-CLICK button.

●To drag and drop

Holding down the L-CLICK button, move the mouse control button until the mouse pointer is over the desired location, then release the L-CLICK button.

●Using the computer’s page up [↑] and down [↓] function Press the PAGE+ and PAGE- buttons to switch PowerPoint® slides.

Ceiling-mounted rear projection

WARNING

•Always obey the instructions listed in IMPORTANT SAFETY INSTRUCTIONS when placing the unit. Attempting to clean/replace the lamp at a high site by yourself may cause you to drop down, thus resulting in injury.

•If you wish to mount the projector on the ceiling, be sure to ask your dealer to do so. Mounting the projector on a ceiling requires special ceiling brackets (sold separately) and specialized knowledge. Improper mounting could cause the projector to fall, resulting in an accident.

•If the projector is ceiling-mounted, install the breaker for turning off the power in case of anomaly. Let everyone involved with the use of the projector know that fact.

Projection Distance and Size

Use the figures, tables, and formulas below to determine the projection size and projection distance. (Projection sizes are approximate values for full-size picture with no keystone adjustment.)

Remote Control Front		Remote Control Rear
Mouse control		L-CLICK
PAGE –	PAGE +
R-CLICK

Screen As seen from above

90°

As seen from the side

Lens center

90°

a

a is the distance (m) between the lens and the screen, and corresponds to a range of 1.07 m to 11.09 m.

projection	projection distance a (m)
size (inches)	min length	max length
	(zooming max)	(zooming min)
30	1.07	1.75
40	1.45	2.35
60	2.19	3.55
80	2.93	4.74
100	3.67	5.93
150	5.53	8.92
200	7.38	–
250	9.24	–
300	11.09	–

20 21