Toshiba TDP-T98 Power Supply Cord Selection, Important Precautions, Moisture Condensation

IMPORTANT SAFETY INSTRUCTIONS (Continued)

POWER SUPPLY CORD SELECTION

19. Replacement Parts

When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock, or other hazards.

(Replacement of the lamp only should be made by users.)

22. Do not use the product in a closed installation state.

Do not place the product in a box or in any other closed installation state. Otherwise it may overheat. This could result in a risk of fire.

If your line voltage is 220 to 240V, use one of the following types of cable.				Using
Plug		Plug
configuration Plug type	Line voltage	configuration Plug type	Line voltage
EURO	220 – 240V	Australian	200 – 240V	Before
		240V
		10A
UK	220 – 240V	Switzerland	200 – 240V
		240V
		6A
Use a 5A fuse which is approved by ASTA		North American	200 – 240V
or BSI to BSI362.

Always replace the fuse cover after	240V
	15A
changing the fuse.

20. Safety Check

Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition.

21.Do not leave thermal-paper documents or easily deformed items on top of the unit or near the air exhaust for long periods of

time.

The heat from the unit could erase the information on the thermal paper, or cause deformation or warping.

IMPORTANT PRECAUTIONS

Save Original Packing Materials

The original shipping carton and packing materials will come in handy if you ever have to ship your projector. For maximum protection, repack the set as it was originally packed at the factory.

Moisture Condensation

Never operate this unit immediately after moving it from a cold location to a warm location. When the unit is exposed to such a change in temperature, moisture may condense on the crucial internal parts. To prevent the unit from possible damage, do not use the unit for at least 2 hours when there is an extreme or sudden change in temperature.

Place and Manner of Installation

•Do not place in hot locations, such as near heating equipment. Doing so could cause malfunction, and shorten the life of the projector.

•Avoid locations with oil or cigarette smoke. Doing so will dirty the optical parts, shortening their lives, and darkening the screen.

•Do not use the product vertically in any upright position or slantwise in an angle of 20 degrees or more.

•Using this instrument near a TV or radio may cause interference to the images or audio sound. If this happens, move it away from the TV or radio.

•Moving the projector from a low-temperature room to a high-temperature room may cause condensation on the lens or internal parts in the instrument. If you continue to use it in that situation, the malfunction may result. Ensure to wait until the condensation naturally disappears.

•In a high altitude location where air is thin, cooling efficiency is reduced so use it with the ambient temperature being lowered.

8 9