Toshiba TLP-X11U, TLP-X21U, TLP-X20U, TLP-X10U Connecting a computer with DVI output connector

Connecting a computer with DVI output connector

You can project the picture by entering the digital RGB signals from a computer with DVI output connector. Check that the power for the projector and computer is off before connecting the cables.

CONTENTS

23

CONTROL USB	MONITOR OUT		COMPUTER IN 1		COMPUTER IN 2
			( Y/PB/PR )
	AUDIO	AUDIO		VIDEO IN
	OUT	IN	R - AUDIO - L		VIDEO S-VIDEO

COMPUTER IN 2 Connector (DVI connector)

For use as both analog RGB2 input and digital RGB input. At shipping from factory, the projector is set so that this connector cannot be selected by the INPUT button. Change the setting on the menu screen when using. 48

AUDIO IN jack

For use as both audio signals for RGB input (analog RGB1/analog RGB2/digital RGB) and Y/PB/PR input.

Installation and connection

TER

IN 2

MPU

CO

TER

IN 1

MPU

R )

CO

B/P

( Y/P

T

OR

OU

NIT

MO

USB

NTROL

CO

IN

S-

VID

EO

EO

VID

VID

IO -

L

IO

R -

AUD

AUD

AU

DIO

IN

T

OU

To COMPUTER IN 2 connector Be sure to connect in the proper direction.

To DVI output port

DVI cable (not supplied)

Computer

To AUDIO IN jack

Audio cable (supplied)

ø 3.5mm Stereo mini-jack To audio output port

Notes

•The COMPUTER IN 2 connector can be used to input either digital RGB or analog RGB signals, depending on the connection cable used.

The projector’s DVI connector is of the DVI analog & digital type. Check the type of output connector on the computer, then purchase the appropriate type of connection cable. (To input analog RGB signals from a computer without a DVI connector, use a DVI cable on which the computer side connector is a mini D-sub 15-pin connector.)

•You may not be able to connect some computers to the projector. For details, consult the dealer.

•Some computers may have output modes which are not compatible with this projector. Check the compatibility of the connectors, signal timing, resolutions, etc.