Adjustments

Keystone correction

– Keystone

Preparation

•Display the image as explained in “Picture Projection”. 21

•Set the POINTER/PJ selector to “PJ”.

SELECT/ADJUST

ON

ON/STANDBY MENU

ENTER

INPUT

LAMP

TEMP

AUTO SET ON/STANDBY

KEYSTONE

KEYSTONE

 

MARKER

LASER

1,7

PJ

2,3,5,6

POINTER

 

 

 

4

L-CLICKR-CLICK

MENU ENTER

RGB VIDEO CAMERA

RESIZE RESET FREEZE

RESET

1 Press MENU to display the menu.

2 Press or to select .

Ke y s t o n e

A u t o s e t

 

 

A d j u s t

–

+

3 Press to select “Auto set”.4 Press ENTER.

The keystone distortion is corrected automatically. For further correction, follow the below steps.

5 Press .6 Press or to correct the distortion.

(–): To reduce the upper width. (+): To reduce the lower width.

7 Press MENU.

The menu disappears.

CONTENTS 30

Notes

•Pressing KEYSTONE on the remote control

can also correct the keystone distortion automatically. 22

•These adjustments are stored until you turn the power off.

•Pressing RESET will return the adjustment or setting currently selected to default.

•Pictures may be slightly deteriorated by the keystone correction.

0 degrees setting for the automatickeystone correction

Depending on the operating condition such as vibration, the distortion may be beyond the automatic keystone correction. The horizontal condition setting (0 degrees setting) may be disordered. In such a case, perform the following 0 degrees setting to correct the distortion.

1)Place the projector on a level surface.

2)On the menu, select “Auto set” in “Keystone”.

3)Press RESET.

Notes

•Do not make the 0 degrees setting on an inclined or unstable surface or in a shaky place as it may not be performed properly.

•To store this setting even if the power is

turned off, follow the procedure of “Saving data”. 34