Connections and installation

(Continued)

Notes

• When the projector is moved from a cold

location to a warm location, or when the

ambient temperature in the projection room

has risen suddenly, moisture may condense

on the lens or the mirror to blur the projected

pictures. In such a case, leave the projector

for an adequate time (1 to 2 hours, depending

on the room’s condition) before using it so it

adjusts to the ambient temperature.

• If the screen is exposed to direct sunlight or

other strong light, the projected picture

becomes too faint to see. Shut out the light

with curtains or other means.

• If the screen and the projector are not

How to use the foot adjuster

The tilt of the projector can be adjusted using the foot adjuster.

1)Lift the front of the projector until a tilt angle desired is obtained and hold down the foot adjuster release button.

The foot adjuster will stretch. Release the button to lock in position.

CONTENTS 20

3)To put the foot adjuster back, hold down the foot adjuster release button and lower the front slowly.

The foot adjuster will put back.

Note

Be sure to hold the projector when putting the foot adjuster back so as not to let the front fall on your fingers.

installed properly, the projected picture may

be distorted.

• If the projector is tilted, the picture may be

distorted. To obtain the best possible picture,

place the projector so it faces the screen

squarely.

Foot adjuster

Foot adjuster

release button

 

2)Turn the foot adjuster to make fine adjustment of the height.

Turn clockwise to lift up.

Turn counterclockwise to lower.

Lift up Lower