11.1 Setup Page

The setup page is the initial page that is displayed when the unit’s IP address is accessed via a web browser. Refer to Figure 11 for a screen shot of the setup page. This page contains the ETH-100’s basic identification and configuration parameters:

Note that the ETH-100 requires valid user authentication whenever any configuration information is modified. This will appear as a browser popup box that will request the user name and password. The initial factory-set value for the username is “admin”, and the password is blank (i.e. do not enter a password). Note that the username and password are case-sensitive, and that the authentication will remain in effect from that point until all browser windows are closed.

Firmware Version:

The current firmware version and the date it was created.

MAC Address:

The unique 48-bit Ethernet MAC ID for this device.

IP Address:

The IP address of the device (i.e.: 10.0.0.100).

Subnet Mask:

The Subnet Mask of the device (i.e.: 255.255.255.0).

Default Gateway:

The Default Gateway of the device (i.e.: 10.0.0.2).

Current Date & Time:

The current date and time set on the device.

 

To change the date: select the check box next to “Date”,

 

change the date to the desired values, and click Apply. If

 

the check box is not selected, the values in the date

 

fields will be ignored.

Update Date & Time:

To change the time: select the check box next to “Time”,

 

 

change the time to the desired value, and click Apply.

 

The time is represented in Military (24 hr.) format. If the

 

check box is not selected, the values in the time fields will

 

be ignored.

 

To change the authentication username for modifying the

 

ETH-100’s configuration parameters: select the check

 

box next to “Username”, type your desired user name

 

(max 10 characters), and click apply. You will be

 

required to enter the current username and password to

 

update your username to its new value. Contact ICC if

Username & Password:

you cannot remember your username.

To change the authentication password for modifying the

 

 

ETH-100’s configuration parameters: select the check

 

box next to “Password", type your desired password

 

(max 10 characters), and click apply. You will be

 

required to enter the current username and password to

 

update your password to its new value. Contact ICC if

 

you cannot remember your password.

By clicking “cancel” before clicking “apply”, all configuration data will be reset to the last applied values. Clicking “help” will open a new browser window displaying some basic help information.

36