DSS® Satellite Receiver Set-up (continued)
OFF: if your DSS® satellite receiver is NON
• Satellite channels will be selected by the own channel selector of the DSS® satellite receiver.
The VCR channel should be set to the output channel of the DSS® satellite receiver.
→Go to step 8.
7 Select “BRAND TYPE” usingSTOP, and enter a brand code of your DSS® satellite receiver using number buttons. Refer to the table on the next page.
Example: For a TOSHIBA DSS® satellite receiver, identified by number 99.
VCR display
Make sure that the background of the above display has changed to the satellite program on channel 200. If not, relocate the DSS® satellite receiver on the VCR so that it can receive the infrared signal.
8 Press PROG. twice to exit.
Notes
•If your satellite channel does not change to 200 in step 7, the DSS® satetllite receiver will not be able to change channels in the timer recording. In this case, set “CONTROL” to “OFF” in step6.
•The VCR Plus+ C 3® system recording is not available on satellite channels.
•The DSS® satellite receiver control is not compatible with the cable box control.
Once you complete the
•POWER (CABLE BOX)
To turn the DSS® satellite receiver on or off.
•CH (CABLE BOX)
To select satellite channels in the upper or lower direction. (not applicable to some brands of DSS® satellite receiver.)
•Number buttons (0 – 9)
To select desired channels to record.
Brand name of your | Brand code |
DSS® satellite receiver | |
TOSHIBA | 99 |
|
|
RCA | 98 |
SONY | 97 |
PANASONIC | 96 |
|
|
38