7
Front connections and controlsIf the power-on light is unlit press the POWER button on
the front of the TV to switch the set on, then press a
number button on the remote control to see the screen.
To put the set into Standby press ion the remote
control. To view the TV press iagain or any of the
number buttons. The picture may take a few seconds to
appear. Standby should only be used for short periods of
time.
To set up the TV you will now need to use the on-screen
menus. Press the MENUbutton on the remote control to
see the top menu bar.
This white menu bar will show five different topics shown
in symbols. As each symbol is selected by pressing the
Sor Rbutton on the remote control, its respective
options will appear below.
To use the options press theQbutton on the remote
control to move down through them and Sor Rto select
the required choice. Follow the on screen instructions.
The functions of each menu are described in detail
throughout the manual.
A wide variety of external equipment can be connected via the sockets located behind the flap on the TV. Do
not use the S-Video and Video sockets at the same time. Press the centre of the flap to open it.
Whilst all the necessary adjustments and controls for the TV are made using the remote control, the buttons on
the TV may be used for some functions.
RED – Power on
Power Button
Green – Timer is set
To alter the volume press —j+.
To alter the programme position press eeFff.
Press MENUand S,R,Qor Pto control the sound
and picture options.
Press EXITto finish.
When connecting mono sound equipment to EXT 5,
connect the audio output of the equipmentto the
L/Monosocket on the TV.
To select the Input, press Buntil the display shows
EXT5as described on page 16. The TV will autmatically
sense the type of signal.
Please always refer to the owner’s manual of the
equipment to be connected for full details.
Please note: Inserting the headphone jack will mute the
sound from all speakers.
Switching on Using the controls and connections
EXT 5