RE200 AC750 WiFi Range Extender User Guide

zLED Explanation:

Name

Status

Indication

 

Solid Green

The Range Extender is connected to the 5G/2.4G wireless network

 

 

of your main Router/AP, and the signal strength is strong.

5G/2.4G

Solid Red

The Range Extender is connected to the 5G/2.4G wireless network

 

of your main Router/AP, but the signal strength is weak.

 

 

 

Off

The Range Extender isn’t connected to your main Router/AP.

 

On

The Range Extender’s wireless function is enabled.

Wireless Signal

Off

The Range Extender’s wireless function is disabled.

 

On

A device is connected to the ETHERNET port, but there is no

 

activity.

 

 

 

 

 

ETHERNET

Flashing

A device is connected to the ETHERNET port, and is active.

 

Off

No device is connected to the ETHERNET port.

 

On

The Range Extender is on.

Power

Off

The Range Extender is off.

 

On

The Range Extender has established a secure connection.

 

Flashing

The Range Extender is establishing a secure connection.

RE

 

 

Off

No active connection.

 

 

 

 

Table 1-1

z (RANGE EXTENDER/WPS): If your Wireless router or AP supports WPS or QSS function, you can press the WPS or QSS button and then press the RANGE EXTENDER button to establish a secure connection between the Wireless router or AP and the Range Extender RE200.

zRESET: This button is used to restore the Range Extender’s factory default settings. There are two ways to reset the Range Extender’s factory defaults:

Method One: With the Range Extender powered on, use a pin to press RESET button (about 1 seconds) until all the LEDs flash once. And then release the button and wait the Range Extender to reboot to its factory default settings.

Method Two: Restore the default settings from “System Tools > Factory Defaults” of the Range Extender's Web-based Management page.

zETHERNET: One 10/100Mbps RJ45 Ethernet port used to add wireless connectivity to an Ethernet-enabled device such as Internet TV, DVR, Gaming console and so on. Please note that this port is not allowed to be connected with router or AP.

3

Page 11
Image 11
TP-Link AC750 manual LED Explanation Name Status Indication, 5G/2.4G