TD-W8960N 300Mbps Wireless N ADSL2+ Modem Router User Guide
21
) Note:
One ETH is allowed to configure as the layer 2 WAN Interface.
4.4.2 WAN Service Choose “Advanced Setup”Æ“WAN Service”, and you will see the WAN Port Information Table in
the screen similar to Figure 4-7, which describes the WAN port settings and the relevant
manipulation to each interface. After you add a new Lay2 Interface, please follow the instructions
below to complete the further configuration of WAN Interface. There are five different
configurations for the connection types, which are PPPoE, IPoE, Bridge, PPPoA, and IPoA. You
can select the corresponding types according to your needs.
Figure 4-7
) Note:
The following section adopts different VPI, VCI to introduce further configuration for the different
connection types, if you need to change the configuration of ATM PVC (VPI/VCI), you should go to
the previous section (4.4.1 Layer2 Interface) to configure them again.
4.4.2.1 ATM-EoA-PPPoE
If your ISP provides a PPPoE connection and you need to use an ATM Interface, follow the steps
below to add a WAN service over a selected ATM interface:
1. Add a new ATM interface and select EoA option for DSL Link Type (4.4.1.1 ATM interface).
2. Click the Add button on the screen Figure 4-7 and you will enter the next screen as shown in
Figure 4-8. Click Next.
Figure 4-8