TP-Link TG-3269 appendix Installation, Appendix A Troubleshooting, Appendix C Contact Information

ØSupports Full Duplex Flow Control (IEEE 802.3x)

ØPCI local bus single-chip Ethernet controller

ØSupports ACPI, PCI power management

ØSupports Auto-Negotiation function, Auto-detects network speed

ØContains two large independent receive and transmit FIFOs

ØOne STP/UTP connector

ØProvides LEDs to indicate network Link/Activity/Speed/ Duplex

ØSupports smart remote boot ROM

ØSupports Drivers for NetWare 4.x,5.x,6.x,Windows 98, Windows ME, Windows NT, Windows 2000, Windows XP, Linux

Chapter 2 Installation

Card Installation

To insert The Product into your computer, follow the steps list below.

1	Turn off the computer and remove its cover.
2	Insert TG-3269 into a PCI slot.
3	Fix the Product to the rear of the computer chassis and put the
	computer cover in order.
4	Connect the adapter to the network with twisted-pair cables.

Driver Installation

The required software is in the diskette.

Appendix A: Troubleshooting

If you experience any problems with the adapter, first please confirm that the appropriate driver is loaded properly,and that the cable is connected to the adapter port soundly. Then check the LED.

The Product provides LEDs to indicate network status.

10 LED, 100 LED, 1000 LED

They all indicate Link/Active/Speed status.

When the 1000 LED is lit, it indicates adapter has been linked to network with the right speed of 1000Mbps. The flash 1000 LED indicates data transmission at the responding port.The 10 LED and 100 LED are similar to the 1000 LED.

FDX LED

It indicates the status that whether or not the adapter works at full duplex mode. When the LED is lit the adapter works at full duplex mode . Otherwise the adapter works at half duplex mode.

If you have other questions, please contact our local FAE.

Appendix B: Technical Specification

ØTopology: Star

ØConnector Supported: Rj45

ØStandard: IEEE802.1P, IEEE802.1Q , IEEE802.3 10Base-T IEEE802.3u 100Base-TX IEEE 802.3ab 1000Base-T

ØTransmission Rate: 10/20Mbps , 100/200Mbps, 2000Mbps

71030428

ØHardware: IBM PC compatibles(It must have PCI slot)

ØIRQ Line: Assigned by system

ØI/O Address: Assigned by system

ØSoftware: Supports Drivers for NetWare 4.x,5.x,6.x, Windows 98, Windows ME, Windows NT, Windows 2000, Windows XP, Linux

ØTemperature: 0 to 40 (Operating)

ØHumidity: 10% to 90% (Non-condensing)

ØPower consumption: 4W(Max)

Appendix C: Contact Information

For help with the installation or operation of the TP-LINK TG-3269 Adapter, please contact us.

TP-LINK TECHNOLOGIES CO., LTD.

Add: Fl.3, Bldg.R1-B, High-Tech Industrial Park, Shennan Road, Shenzhen, China

E-mail:support@tp-link.com

Website: http://www.tp-link.com

Made in China	2.0
	Ver:

User's Guide

TG-3269

Gigabit Ethernet Adapter

3 4 5 2