Weider 831.159830 user manual Troubleshooting And Maintenance, Tightening The Cables

TROUBLESHOOTING AND MAINTENANCE

Make sure all parts are properly tightened each time you use the weight system. Replace any worn parts immedi- ately. The weight system can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents.

TIGHTENING THE CABLES

Woven cable, the type of cable used on the weight system, can stretch slightly when it is first used. If there is slack in the cables before resistance is felt, the cables should be tightened. Slack can be removed from the cables in several different ways.

When you are tightening the cables, note that they are linked into two distinct groups. The Rear Cable (70), the Low Cable (71), the Butterfly Cable (73), and the Ab Cable (74) are all connected to the small weight stack. All three cables will be tightened by tightening the Rear Cable at the small weight stack, or by adjusting the

3 1/2” Pulleys (35) in either set of Pulley Plates (32).

The Press Cable (72) is attached to the large weight stack. The Press Cable can be tightened at the large weight stack or by moving the “V”-Pulleys (34) on the Press Upright (5) and the Press Seat Frame (12).

The Pulley Plates (32) have four sets of adjustment holes for each 3 1/2” Pulley (35). Slack can be removed from the cables by moving one or both Pulleys to a set of holes closer to the center of the Pulley Plates.

To move a 3 1/2” Pulley (35), remove the 3/8” Nylon Locknut (90) and the 3/8” x 2” Bolt (93) from the Pulley Plates (32), the Cable Trap (38), and Pulley. Re-attach the Pulley and Cable Trap to the next set of holes in the Pulley Plates with the Bolt and Nylon Locknut. Note: Begin by moving the bottom Pulley up one set of holes. If the cables are still too loose, move the top Pulley down one set of holes, until the slack in the cables has been removed.

The threaded ends on the Rear Cable (70) and the Press Cable (72) attached to the weight stacks can be used to tighten the cables.

To tighten the Rear Cable (70), remove the 5/16” x

1 3/4” Bolt (96) and the 5/16” Nylon Locknut (86) from the “U”-Bracket (33) and the Short Weight Tube (44).

Tighten the 1/4” Nylon Locknut (103) at the end of the Rear Cable (70) a few turns. Re-attach the “U”- Bracket (33) to the Short Weight Tube (44) with the 5/16” x 1 3/4” Bolt (96) and the 5/16” Nylon Locknut (86).

The Press Cable (72) can be tightened in the same manner.

	32
Adjustment
Holes	93
90
38	35
	70
	96
33
86	99
	103
	44
28