45.Remove the 3/8” Nylon Jamnut (92) from the 3/8” x 4 3/4” Bolt (102) inserted into the Butterfly Upright (4) in step 43.
Wrap the Low Cable (71) around a 3 1/2” Pulley
(35)in the direction shown. Attach the Pulley and a Cable Trap (38) to the 3/8” x 4 3/4” Bolt (102) with the 3/8” Nylon Jamnut (92). Make sure the
Cable Trap is positioned to hold the Cable in the groove of the Pulley.
46.Attach the Low Cable (71) to the Leg Lever (13) with a 5/16” x 2 3/4” Shoulder Bolt (108), a 5/16” Washer (100), and a 5/16” Nylon Jamnut (77).
47.Remove a Pro Pulley (110) from the bag labeled “PULLEY BAG 2.”
Identify the Press Cable (72). It is approximately 387 5/8” long and it has a ball on one end and a threaded shaft on the other.
Wrap the Press Cable (72) around the Pro Pulley
(110)in the direction shown. Attach the Pulley to the Press Top Frame (9) with a 3/8” x 3 1/2” Bolt (111), a 3/8” Washer (97), and a 3/8” Nylon Jamnut (92). Make sure the Cable is between the Pulley and the pin on the Press Top Frame.
48.Route the threaded end of the Press Cable (72) around the 3 1/2” Pulley (35) that was attached to the Press Top Frame (9) in step 16. Make sure the Cable Trap (38) is positioned to hold the Cable in the groove of the Pulley. Properly tighten the 3/8” Nylon Locknut (not shown) attached to the 3/8” x 4” Bolt (78).
45 |
|
|
|
|
| 71 |
|
4 |
|
|
|
| 38 |
|
|
102 | 35 | 92 | |
|
| ||
46 |
|
|
|
100 |
|
|
|
77 |
|
|
|
13 |
|
|
|
|
|
| 108 |
|
| 71 |
|
47 |
|
|
|
92 | 97 |
|
|
| 9 |
|
|
| Pin | 110 | 111 |
|
| ||
|
|
| |
| 72 |
|
|
48 |
|
|
|
|
|
| 38 |
| 9 |
| 35 |
|
| 78 | |
|
|
| |
|
|
| 72 |
19
