Frame Assembly
1.Before beginning, be sure that you have read and understood the information on page 5.
Locate and open the parts bag labeled
“FRAME ASSEMBLY.”
Press a 2” Square Inner Cap (67) into each end of the Butterfly Base (1).
Insert four 5/16” x 2 1/2” Carriage Bolts (75) and a a 3/8” x 3 1/2” Carriage Bolt (95) up through the indicated holes in the Butterfly Base (1). Place the Butterfly Base flat on the floor. Note: If the Bolts fall out, secure them by putting a small piece of tape over the head of each Bolt.
2.Press three 2” Square Inner Caps (67) into the Center Base (2). Insert a 3/8” x 3 1/2” Carriage Bolt (95) up through the indicated hole in the Center Base.
Attach the Center Base (2) to the Butterfly Base (1) with two 5/16” x 2 3/4” Bolts (89), a Medium Support Plate (109), and two 5/16” Nylon Locknuts (86). Do not tighten the Nylon Locknuts yet.
Note: There are three kinds of Support Plates. The main difference between them is the dis- tance between the holes. When you need a Support Plate, find the kind with holes that will fit over the bolts you are using.
3.Press a 2” Square Inner Cap (67) into the end of the Press Base (3).
Insert four 5/16” x 2 1/2” Carriage Bolts (75) up through the indicated holes in the Press Base (3). Insert a 3/8” x 2 1/2” Carriage Bolt (76) and a 3/8” x 4” Carriage Bolt (112) up through the indicated holes at the end of the Press Base.
Attach the Press Base (3) to the Center Base (2) with two 5/16” x 2 3/4” Bolts (89), a Medium Support Plate (109), and two 5/16” Nylon Locknuts (86). Do not tighten the Nylon Locknuts yet.
6
1 |
|
|
|
|
|
|
|
|
|
| 67 |
| 1 |
|
|
| 95 |
|
|
|
|
| |
|
|
| 75 |
|
|
| 75 |
|
|
|
|
67 |
|
|
|
|
|
2 |
|
|
|
|
|
89 | 109 |
|
|
|
|
|
| 86 |
|
| 67 |
|
|
|
|
| |
1 | 86 | 2 |
|
|
|
|
|
| 95 |
|
|
3 |
|
|
|
|
|
|
|
|
| 86 | 67 |
| 2 |
|
|
| |
|
|
|
|
| |
|
| 86 |
|
| 109 |
| 3 |
|
|
|
|
|
|
|
|
| 89 |
|
|
| 75 | 76 | 112 |
|
|
|
| ||
|
|
|
|
| |
| 75 |
|
|
|
|