65.Press a 1 3/4” Square Inner Cap (68) into the indicated end of the Adjustment Tube (15).
Attach the Adjustment Tube (15) to the bracket (not visible in the drawing) on the back of the Leg Press Plate (16) with a 5/16” x 2 1/2” Bolt (87), two 5/16” Washers (100), and a 5/16” Nylon Locknut (86).
Place the Adjustment Tube (15) in the bracket on top of the Leg Press Lever (14) and secure it with the Adjustment Pin (40). Note: The lip on the
Leg Press Plate (16) must be on the upper edge.
66.Press four 3/4” Round Inner Caps (64) into the ends of the two Pad Tubes (51).
Insert a Pad Tube (51) into the indicated hole in the Leg Lever (13). Slide two Foam Pads (52) onto the ends of the Pad Tube.
Insert a Pad Tube (51) into the indicated hole in the Butterfly Leg (11). Slide two Foam Pads (52) onto the ends of the Pad Tube.
67.Attach the Curl Pad (22) to the Curl Post (21) with two 1/4” x 3/4” Bolts (98).
65 |
|
|
|
Lip | 87 | 15 | 40 |
| |||
100 |
| ||
|
|
| 68 |
|
|
| 14 |
| 100 | 86 | |
| 16 |
|
|
66 |
|
|
|
64 |
|
|
|
| 52 |
|
|
| 51 |
| 64 |
|
|
| |
|
|
| 52 |
| 13 |
|
|
| 11 |
|
|
|
|
| 64 |
67 |
|
|
|
| 22 |
| 98 |
|
|
| |
| 21 |
|
|
68.Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in ADJUSTMENTS, beginning on the following page.
Before using the weight system, pull each cable a few times to be sure that the cables move smoothly over the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPORTANT: If the cables are not properly installed, they may be damaged when heavy weight is used. See the CABLE DIAGRAMS on pages 30 and 31 for proper cable routing. If there is any slack in the cables, you will need to remove it by tightening the cables; see TROUBLESHOOTING AND MAINTENANCE on page 28.
24
