6.Command Specification

REQUEST SENSE

0Bh

 

 

 

ABORTED COMMAND

 

 

 

 

 

 

 

 

43

00

MESSAGE ERROR – Unexpected Message phase.

 

 

 

 

 

 

 

 

45

00

SELECT OR RESELECT FAILURE - SCSI Selection/ Re-selection error.

 

 

 

 

 

 

 

 

47

00

SCSI PARITY ERROR - SCSI Parity Error detected and drive proceeded to Status

 

 

 

 

 

phase.

 

 

48

00

INITIATOR DETECTED ERROR MESSAGE RECEIVED.

 

 

 

 

 

 

 

 

 

4A

00

COMMAND PHASE ERROR

 

 

 

 

 

 

 

 

 

4B

00

DATA PHASE ERROR – Possible DMA error

 

 

 

 

 

 

 

 

 

4E

00

OVERLAPPED COMMANDS ATTEMPTED - Host issued a new command to the drive

 

 

 

 

 

while a previous command was being executed.

0Dh

 

 

 

VOLUME OVERFLOW

 

 

 

 

 

 

 

00

02

END-OF-PARTITION/MEDIUM DETECTED - During Write type operation.

0Eh

 

 

 

 

MISCOMPARE. Not supported by the SDX-800V

0Fh

 

 

RESERVED. Not used by SDX-800V

REQUEST SENSE returns the CHECK CONDITION status only to report fatal errors for the REQUEST SENSE command.

For example:

The target receives a non ZERO reserved bit in the command descriptor block. An un-recovered parity error occurs on the Data Bus.

A target malfunction prevents return of the sense data. The Allocation Length falls between block boundaries.

Following a fatal error on REQUEST SENSE, the sense data should be considered invalid. The host may attempt recovery by selecting the drive and issuing a BUS DEVICE RESET message directly following the IDENTIFY message. This forces the drive to do a hard reset. If the fault persists, the host should deny access to the drive.

6-94

SONY AIT-3Ex drive SDX-800V series Ver.1.1

Page 152
Image 152
Sony SDX-800V/R manual Aborted Command, Initiator Detected Error Message Received, Command Phase Error, Volume Overflow