Fujitsu M2488 manual Table F-19. Routine 80 Servo Diagnostic Error Codes

M2488 PRODUCT GUIDE DIAGNOSTIC TESTS AND ERROR CODES

Table F-19. Routine 80 - Servo Diagnostic Error Codes

ROUTINE	TEST	TITLE	ERROR	DESCRIPTION
			CODE
0x80	*	Servo Diagnostic Tests	0xE0	Test initialization error, the controller could
				not sense the presence of a DVL card. The
				DTC card must be connected to a DVL card in
				order to run this test.
			0xE1	Test initialization error, a servo unload com-
				mand failed while attempting to eject a car-
				tridge.
			0xE2	Servo reported error while attempting to
				unload a cartridge during test initialization.
0x80	0x01	Servo Diag: Logic test	0x41	Dummy signal of the file reel tachometer is
				wrong
			0x42	GAP counter is wrong
			0x43	RRC counter is wrong
			0x44	Forward direction of the file reel tachometer is
				wrong
			0x45	Backward direction of the file reel tachometer
				is wrong
			0x46	Dummy signal of the machine reel tachometer
				is wrong
			0x47	Forward direction of the machine reel
				tachometer is wrong
			0x48	Backward direction of the machine reel
				tachometer is wrong
			0xE3	Servo command was not accepted; sense
				information was built
			0xE4	Servo command was accepted but failed to
				complete within 60 seconds
			0xE5	Servo error occurred that was not reported as
				a diagnostic error.
0x80	0x02	Servo Diag: Photo sensors test	0x02	The tape path home sensor is off
			0x03	The cartridge in sensor is on
			0x04	The tape path “CT” sensor is off
			0x05	The tape path “MR” sensor is on
			0x06	The cartridge in sensor in on
			0x07	The file protect sensor is off
			0x08	The cleaning cartridge sensor is on

DIAGNOSTIC TESTS AND ERROR CODES

April 1997 CG00000-011503 REV. A F-69