Fujitsu M2488 manual Diagnostic Tests and Error Codes

DIAGNOSTIC TESTS AND ERROR CODES M2488 PRODUCT GUIDE

DIAGNOSTIC TESTS AND ERROR CODES

Table F-22. Routine 81 - Manufacturing Test Diagnostic Error Codes

ROUTINE	TEST	TITLE	ERROR	DESCRIPTION
			CODE
0x81	*	MFG tests	0xE0	DVL card not detected. This test cannot be
				run without a DVL card connected to the DTC
				card
			0xE1	Drive NOT READY error. A working tape
				must be loaded to run this test.
0x81	0x01	Get MFG Parameters	-	No error codes specific to this test
0x81	0x02	Display MFG Parameters	-	No error codes specific to this test
0x81	0x03	Clear Log Counters	-	No error codes specific to this test
0x81	0x04	Write BOT - EOT test	0x01	Cartridge not installed or drive NOT READY
				error. A tape cartridge must be loaded before
				this test can be run.
			0x02	Cartridge WRITE PROTECT error. The car-
				tridge must not be write protected for this test.
			0x03	Buffer space request not granted for data
				transfer.
			0x04	Data transfer timed out.
			0x05	Fatal error detected during data transfer.
			0x06	Bad status reported on data transfer complete.
			0x07	Logical EOT encountered during data trans-
				fer.
			0x08	Buffer flush timeout. Write from data buffer
				to tape was not completed in the allocated
				time.
			0x09	Write data in error reported at end of data
				transfer.
0x81	0x05	Read BOT - EOT test	0x01	Cartridge not installed or drive NOT READY
				error. A tape cartridge must be loaded before
				this test can be run.
			0x02	Error detected while requesting buffer space
				for data transfer.
			0x03	Data transfer timeout error.
			0x04	Error reported during data transfer.
			0x05	Fatal error reported at completion of data
				transfer.
			0x06	Incorrect transfer length, retry required, or
				recovered error and incorrect length reported
				at end of data transfer.

F-74 CG00000-011503 REV. A April 1997