Fujitsu M2488 manual Diagnostic Tests and Error Codes

DIAGNOSTIC TESTS AND ERROR CODES

DIAGNOSTIC TESTS AND ERROR CODES				M2488 PRODUCT GUIDE
	Table F-19. Routine 80 - Servo Diagnostic Error Codes (Continued)
ROUTINE	TEST	TITLE	ERROR	DESCRIPTION
			CODE
0x80	0x02	Servo Diag: Photo sensors test	0x09	The cartridge mount sensor is on
			0xE3	Servo command was not accepted; sense
				information was built
			0xE4	Servo command was accepted but failed to
				complete within 60 seconds
			0xE5	Servo error occurred that was not reported as
				a diagnostic error.
0x80	0x03	Servo Diag: Loader test	0x01	Loader downward motion is too slow
			0x02	Loader downward motion is too fast
			0x03	Loader upward motion is too slow
			0x04	Loader upward motion is too fast
			0xE3	Servo command was not accepted; sense
				information was built
			0xE4	Servo command was accepted but failed to
				complete within 60 seconds
			0xE5	Servo error occurred that was not reported as
				a diagnostic error.
0x80	0x04	Servo Diag: Threader test	0x01	Threader forward motion is too slow
			0x02	Threader forward motion is too fast
			0x03	Threader backward motion is too slow
			0x04	Threader backward motion is too fast
			0xE3	Servo command was not accepted; sense
				information was built
			0xE4	Servo command was accepted but failed to
				complete within 60 seconds
			0xE5	Servo error occurred that was not reported as
				a diagnostic error.
0x80	0x05	Servo Diag: Tachometer test	0x01	The machine reel tachometer “A” is always
				“1”
			0x02	The machine reel tachometer “A” is always
				“0”
			0x03	The machine reel tachometer “B” is always
				“1”
			0x04	The machine reel tachometer “B” is always
				“0”
			0x05	The machine reel tachometer “A” and “B”
				changed at the same time

F-70 CG00000-011503 REV. A April 1997