Fujitsu manual Media Changer COMMANDSM2488 Product Guide, Mode Select MC Sense Keys

MEDIA CHANGER COMMANDSM2488 PRODUCT GUIDE

For more information on the Medium Changer Mode Parameters see section 6-3 on page 6-32.

6-2.2.4 MODE SELECT MC Sense Keys

One of the following sense keys may be returned if a CHECK CONDITION was indicated:

SENSE KEY	CONDITION		DESCRIPTION
1h	RECOVERED ERROR	Recovery was performed when writing buffered data before the buff-
		ered mode operation occurred in MODE SELECT command.
3h	MEDIUM ERROR	1. Write of buffered data failed due to defective tape.
		2.	An attempt was made to write 36-track data on 18-track formatted
			medium.
4h	HARDWARE ERROR	1. SCSI interface error occurred due to hardware failure (e.g. transfer
			of MODE SELECT data failed due to hardware failure).
		2.	Write of buffered data failed due to a hardware failure.
5h	ILLEGAL REQUEST	1. Reserved bit was found set in the CDB of the MODE SELECT
			command.
		2.	Flag bit in the MODE SELECT CDB was set and Link bit was not
			set.
		3.	There is a parameter list error.
6h	UNIT ATTENTION	Indicates the MODE SELECT command was not performed due to
		one of the following:
		1.	The tape cartridge may have been changed.
		2.	The target has been reset.
		3.	The Mode parameters have been changed by another initiator.
		4.	The version of the microcode has been changed (microcode down-
			loaded).
		5.	A cartridge was loaded with a tape length that is too long or too
			short.
Bh	ABORTED COMMAND	MODE SELECT command was aborted.
Dh	VOLUME OVERFLOW	Write of buffered data prior to the MODE SELECT operation failed
		because physical End-of-Tape has been reached.

6-10 CG00000-011503 REV. A March 1997