Fujitsu M2488 manual Mode Sense Sense Keys, Sense KEY Condition Description

TAPE UNIT SCSI COMMANDS M2488 PRODUCT GUIDE

4-3.13.5 MODE SENSE Sense Keys

One of the following sense keys may be returned if a CHECK CONDITION was indicated:

SENSE KEY	CONDITION		DESCRIPTION
1h	RECOVERED ERROR	Recovery was performed when writing buffered data, before the
		buffered mode operation occurred in MODE SENSE command.
3h	MEDIUM ERROR	1. Write of buffered data failed due to a defective tape.
		2.	An attempt was made to write 36-track data on 18-track format-
			ted medium.
4h	HARDWARE ERROR	1. SCSI interface error occurred due to a hardware failure (e.g.
			transfer of MODE SENSE data failed due to a hardware fail-
			ure).
		2.	Write of buffered data failed due to a hardware failure.
5h	ILLEGAL REQUEST	1. Reserved bit was found set in the CDB of the MODE SENSE
			command.
		2.	Flag bit in the MODE SENSE CDB was set and the Link bit
			was not set.
6h	UNIT ATTENTION	Indicates the MODE SENSE command was not performed due to
		one of the following:
		1.	The tape cartridge may have been changed.
		2.	The target has been reset.
		3.	The Mode parameters have been changed by another initiator.
		4.	The version of the microcode has been changed (microcode
			downloaded).
		5.	A cartridge was loaded with a tape length that is too long or too
			short.
Bh	ABORTED COMMAND	MODE SENSE command was aborted.
Dh	VOLUME OVERFLOW	Write of buffered data prior to the MODE SENSE operation failed
		because physical End-of-Tape has been reached.

4-62 CG00000-011503 REV. A April 1997