Fujitsu M2488 manual Load Unload Sense Keys, Sense KEY Condition Description

M2488 PRODUCT GUIDE TAPE UNIT SCSI COMMANDS

4-3.7.3 LOAD UNLOAD Sense Keys

One of the following sense keys may be returned if a CHECK CONDITION was indicated:

SENSE KEY	CONDITION		DESCRIPTION
1h	RECOVERED ERROR	Recovery was performed when writing buffered data before the load
		or unload operation occurred.
2h	NOT READY	Logical Unit was not ready. (Tape cartridge was not loaded or logical
		unit was not made ready)
3h	MEDIUM ERROR	1. Write of buffered data failed due to a defective tape.
		2.	An attempt was made to write 36-track data on 18-track formatted
			medium.
4h	HARDWARE ERROR	1. Write of buffered data failed due to a hardware failure.
		2.	The load or unload operation was not completed because of a hard-
			ware failure.
5h	ILLEGAL REQUEST	1. Reserved bit was found set in the CDB of the LOAD UNLOAD
			command.
		2.	Medium Changer is attached but it was in System Mode when the
			LOAD UNLOAD command was issued.
6h	UNIT ATTENTION	Indicates the LOAD UNLOAD command was not performed due to
		one of the following:
		1.	The tape cartridge may have been changed.
		2.	The target has been reset.
		3.	The Mode parameters have been changed by another initiator.
		4.	The version of the microcode has been changed (microcode down-
			loaded).
		5.	A cartridge was loaded with a tape length that is too long or too
			short.
Bh	ABORTED COMMAND	LOAD UNLOAD command was aborted. The LOAD UNLOAD
		command can be reissued.

April 1997 CG00000-011503 REV. A 4-27