Fujitsu M2488 manual Diagnostic Tests and Error Codes

DIAGNOSTIC TESTS AND ERROR CODES

DIAGNOSTIC TESTS AND ERROR CODES				M2488 PRODUCT GUIDE
Table F-9. Routine 7 - SCSI Protocol Controller Diagnostic Error Codes (Continued)
ROUTINE	TEST	TITLE	ERROR	DESCRIPTION
			CODE
0x07	0x05	SPC MPU bus parity test	0x08	The SPC interrupt request could not be
				cleared
			0x09	CP bus parity error was not reported as
				expected
			0x0A	Unexpected Check 1 condition was reported
				after attempting to clear the Check 1 CP bus
				parity error

Table F-10. Routine 8 - Formatter Counters Diagnostic Error Codes

ROUTINE	TEST	TITLE	ERROR	DESCRIPTION
			CODE
0x08	0x01	Formatter Counter 0 test	0x01	The Formatter Counter 0 count enable register
				could not be cleared
			0x02	A data miscompare occurred walking a one
				through the Formatter Counter 0 high byte
				count register
			0x03	A data miscompare occurred walking a one
				through the Formatter Counter 0 low byte
				count register
			0x04	Test Jump Carry Out bit for the high byte
				count of Formatter Counter 0 was set prema-
				turely before counter was started
			0x05	An unexpected value was read in the count
				enable register for Formatter Counter 0 after
				the high byte counter finished running
			0x06	The high byte count for Formatter Counter 0
				did not contain the expected value after the
				counter finished running
			0x07	Test Jump Carry Out bit for the high byte
				count of Formatter Counter 0 was not set as
				expected after the counter finished running
			0x08	Test Jump Carry Out bit for the low byte
				count of Formatter Counter 0 was set prema-
				turely before counter was started
			0x09	An unexpected value was read in the count
				enable register for Formatter Counter 0 after
				the low byte counter finished running

F-22 CG00000-011503 REV. A April 1997