Fujitsu M2488 manual Diagnostic Tests and Error Codes

M2488 PRODUCT GUIDE					DIAGNOSTIC TESTS AND ERROR CODES
	Table F-14. Routine 12 - EDRC Address Bus Diagnostic Error Codes (Continued)
ROUTINE		TEST	TITLE	ERROR		DESCRIPTION
				CODE
0x12		0x01	SDDP-R20 buffer flush signal	0x03		when transferring data from the SPC send
			test, mode 14h			buffer to the SPC data fifo, the SPC-ssig regis-
						ter did not have the expected bits set:
						SCSI_REQ, SCSI_BSY, xfer_phase.
				0x04		when transferring data from the SPC send
						buffer to the SPC data fifo, the SPC-ssig regis-
						ter did not have the expected bits set:
						~SCSI_REQ, SCSI_ACK, SCSI_BSY,
						xfer_phase.
				0x05		host data transfer end of transfer was received
						when not expected, check to see if flush is tied
						high to some other signal.
				0x06		host data transfer end of transfer was not
						received when expected, check to see if flush
						is tied low to some other signal.
				0x07		All the data expected to be transferred out of
						the SPC data fifo was not transferred to the
						SDDP.
0x12		0x02	SDDP-R20 testing 64k sgc-i-	0x01		after a write diag operation was initialized in
			mem, mode 14h			the spc chip, the SPC-status register did not
						have one of the following:
						SPC_data_trans_rdy, SPC_busy, or
						SPC_data_reg_empty.
				0x02		A non SUCCESS status was returned from
						the function call rm_request_wrtbuffer.
				0x03		when transferring data from the SPC send
						buffer to the SPC data fifo, the SPC-ssig regis-
						ter did not have the expected bits set:
						SCSI_REQ, SCSI_BSY, xfer_phase.
				0x04		when transferring data from the SPC send
						buffer to the SPC data fifo, the SPC-ssig regis-
						ter did not have the expected bits set:
						~SCSI_REQ, SCSI_ACK, SCSI_BSY,
						xfer_phase.
				0x05		when transferring data from the SPC send
						buffer to the SPC data fifo, the SPC-ssig regis-
						ter did not have the expected bits set:
						SCSI_REQ, SCSI_BSY, xfer_phase.
				0x06		when transferring data from the SPC send
						buffer to the SPC data fifo, the SPC-ssig regis-
						ter did not have the expected bits set:
						~SCSI_REQ, SCSI_ACK, SCSI_BSY,
						xfer_phase.

DIAGNOSTIC TESTS AND ERROR CODES

April 1997 CG00000-011503 REV. A F-39